Most of what makes pond water dirty starts at the surface: leaves, pollen, seeds and insects. A pond skimmer catches all of it before it sinks and rots. It is the single piece of equipment that saves the most work on a backyard pond, and it is hidden in the edge so you barely see it.
A pond skimmer is a box set into the pond's edge at the water line. The pump inside pulls surface water through it, a net or basket traps floating debris, filter mats catch finer dirt, and the cleaned water is pumped to the waterfall filter. Most ponds with a pump and waterfall benefit from one; it keeps the water clearer, cuts down on sludge and protects the pump. Very small ponds and pondless waterfalls can do without.
How a pond skimmer works
Water flows over a floating flap at the front, called a weir door, and into the box. Here is what happens inside:
Because the pump sits inside the skimmer, it stays hidden, quiet and protected from leaves and fish. It is also easy to reach when it needs service.
A pond with a skimmer vs without one
Here is what changes when a pond has a skimmer.
Leaves and pollen float for a few days before sinking. A skimmer gets them while they are still on top.
Do you need a pond skimmer?
Most of the ponds we build on Long Island have one. You will get the most out of a skimmer if:
- Trees are nearby, especially oaks and maples that drop leaves for weeks every fall.
- You keep fish, whose waste and uneaten food add to the debris.
- The pond has a waterfall, since the skimmer is the natural place for the pump that feeds it.
- You want less clean-up: emptying a net takes minutes, removing sludge takes a day.
Where to put a pond skimmer
Opposite the waterfall
Water then flows the full length of the pond, from the falls to the skimmer, so there are no still corners.
Downwind
Wind pushes floating leaves to one side of the pond. Put the skimmer on that side and the wind does half the work.
Level with the water line
The opening must sit at the surface, with water about halfway up the weir door. Set it on firm, level ground so it never tips.
With the falls at one end and the skimmer at the other, the whole pond keeps moving.
How to size a skimmer
Skimmers are rated by how much water they can handle, in gallons per hour (GPH), so match the skimmer to the pump that will sit inside it. The pump in turn is sized to the waterfall and the pond (we will cover that in our pump sizing guide). Very large or irregular ponds often use two skimmers so no cove is left out, and a deep koi pond may pair a skimmer with a bottom drain, as explained in our koi pond filtration guide.
Five minutes a week: skimmer care
A skimmer only helps if it is emptied. Here is the routine.
Empty the net or basket
Once a week from spring to summer, every day or two in October when the leaves come down.
Rinse the filter mats
When the flow drops, usually every few weeks in summer. Rinse them in pond water, not under the hose.
Check the water level
If the level falls below the weir door, the pump can run dry and burn out. Top off with treated water, and if it keeps falling, check whether your pond is leaking.
Look at the weir door
It should float freely. A stuck door lets debris back out into the pond.
Quick skimmer troubleshooting
Waterfall weak: the net or mats are clogged. Empty and rinse, then see pond pump problems if it is still weak. Pump sucking air or rattling: the water level is too low. Top off right away. Net full every day in fall: cover the pond with a leaf net until the trees are bare. Debris collecting in one corner: the skimmer is on the wrong side or the flow is too low. A pro can add a second skimmer or reposition the flow.Paradise Ponds & Falls installs skimmers in new and existing ponds and services them on our pond maintenance visits across Nassau and Suffolk County.
Related: how an ecosystem pond uses a skimmer and waterfall filter together, our pond clean-out process, and how we build a pond.
Pond skimmer FAQs
Do I need a pond skimmer?
If your pond has a pump, a waterfall, fish or trees nearby, a skimmer will keep it noticeably cleaner and protect the pump. Pondless waterfalls and very small ponds without a pump can do without one.
How often should I empty my pond skimmer?
About once a week from spring to summer, and every day or two in fall when leaves are dropping. Rinse the filter mats when the flow drops.
Can I add a skimmer to an existing pond?
Yes. It means cutting into the edge, connecting the liner to the skimmer and re-plumbing the pump, so it is a job for a pond pro, but it is one of the most common upgrades we make.
Where should a pond skimmer be placed?
Opposite the waterfall and on the downwind side, set level so the water sits about halfway up the opening.
Is a floating skimmer as good as a skimmer box?
A floating skimmer helps in a small pond, but a built-in skimmer box handles far more debris, hides the pump and holds filter mats, so it is the better choice for most backyard ponds.